DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0711	FLUID TEMP SENSOR A (Transmission Fluid Temperature Sensor A Circuit Range/Performance)	1	Diagnosis condition	When all of the following conditions are satisfied. TCM power supply voltage: More than 11 V CAN communication is normal Engine speed: 450 rpm or more Accelerator pedal position: 3 deg. or more Vehicle speed: 10 km/h (7 MPH) or more U0100, P0705 and P0706 are not detected. Shift position: "D" position
			Signal	CVT fluid temperature sensor signal
			Threshold	CVT fluid temperature does not rise to 10 deg. C (50 deg. F) after driving for a certain period of time with the TCM-received fluid temperature sensor value between - 40 deg. C (-40 deg. F) and 9 deg. C (48.2 deg. F).
			Diagnosis delay time	--
		2	Diagnosis condition	All of the following conditions are satisfied within 2 seconds after the ignition switch is turned ON. U0073, U0100, P0712 and P0713 are not detected. CAN communication is normal. TCM power supply voltage: More than 11 V The difference between CVT fluid temperature and engine coolant temperature is 55 deg. C (131 deg. F) or more, or -27 deg. C (-16 deg. F) or less.
			Signal	CVT fluid temperature sensor signal
			Threshold	When all of the following conditions are satisfied ECM is normal. Diagnosis condition is satisfied.
			Diagnosis delay time	Maintained for 300 seconds