DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Shift the selector lever through entire positions from "P" to "L". (Hold the selector lever at each position for 40 seconds or more.)
- Check the first trip DTC.
Is "P0706" detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END