PR25DD engine: Installation
WARNING: This page is about a different variant/trim than selected.
- Apply liquid gasket (B) to the positions (A) shown.
- Use Genuine Silicone RTV Sealant or equivalent. Refer to HOW TO USE THIS INFORMATION : Recommended Chemical Products and Sealants .
(1)
: Cylinder head
(C)
: 10 mm (0.39 in)
(D)
: Camshaft bracket
- Install rocker cover gasket to rocker cover.CAUTION:
- Do not reuse rocker cover gasket.
- Do not drop or shock rocker cover.
- Discard any rocker cover which has been dropped or shocked.
NOTE: Make sure rocker cover gasket is securely installed in the groove in the rocker cover. - Install the rocker cover and tighten the bolts to the specified torque in the sequence shown.
Step 1
: 1.96 N.m (0.20 kg-m, 17 in-lb)
Step 2
: 8.33 N.m (0.85 kg-m, 74 in-lb)
- Installation of the remaining components is in the reverse order of removal.