DRIVE BELT : Inspection
WARNING: This page is about a different variant/trim than selected.
|
1. |
Generator |
2. |
Drive belt auto-tensioner |
3. |
Crankshaft pulley |
|
4. |
A/C compressor pulley |
5. |
Water pump pulley |
6. |
Drive belt |
|
A. |
View A |
B. |
New drive belt range |
C. |
Possible use range |
|
D. |
Indicator (notch) |
WARNING:
Perform this step when engine is stopped.
- Check that the indicator [notch on fixed side (C)] of drive belt auto tensioner is within the possible use range (A) shown.NOTE:
- Check drive belt auto tensioner indication when the engine is cold.
- When new drive belt is installed, the indicator (notch on fixed side) should be within range (B).
- Visually check entire drive belt for wear, damage or cracks.
- If the indicator (notch on fixed side) is out of the possible use range or belt is damaged, replace drive belt.