Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- If removed, install the water pump and tighten the bolts to the specified torque in the sequence shown.CAUTION: Do not reuse water pump gasket.
Water pump bolts
: 25 N.m (2.6 kg-m, 18 ft-lb)
- Install the water pump housing and tighten bolts to the specified torque in the sequence shown.CAUTION: Do not reuse water pump housing gasket.
Water pump housing bolts
: 50 N.m (5.1 kg-m, 37 ft-lb)
- Installation of the remaining components is in the reverse order of removal.
- Refill the engine coolant. Refer to Refilling .