ENGINE MECHANICAL SYSTEM : Commercial Service Tools or/and Repair Part

WARNING: This page is about a different variant/trim than selected.

(TechMate No.) Tool name	Description
(--) Pulley holder	Courtesy of NISSAN NORTH AMERICA, INC.	Crankshaft pulley removing and installing
(--) Valve spring compressor Attachment Adapter	Courtesy of NISSAN NORTH AMERICA, INC.	Disassembling and assembling valve mechanism Part (1) is a component of KV10116200, but Part (2) is not so.
(--) Valve oil seal puller	Courtesy of NISSAN NORTH AMERICA, INC.	Removing valve oil seal
(--) Valve oil seal drift	Courtesy of NISSAN NORTH AMERICA, INC.	Installing valve oil seal Use side A. a: 20 (0.79) dia. d: 8 (0.31) dia. b: 13 (0.51) dia. e: 10.7 (0.421) c: 10.3 (0.406) dia. f: 5 (0.20) Unit: mm (in)
(--) Pulley puller	Courtesy of NISSAN NORTH AMERICA, INC.	Removing crankshaft pulley
(--) Heated oxygen sensor wrench	Courtesy of NISSAN NORTH AMERICA, INC.	Loosening or tightening air fuel ratio (A/F) sensor For 22 mm (0.87 in) width hexagon nut
(J-43897-18) (J-43897-12) Oxygen sensor thread cleaner	Courtesy of NISSAN NORTH AMERICA, INC.	Reconditioning the exhaust system threads before installing a new oxygen sensor (Use with anti-seize lubricant shown below.) J-43897-18 (18 mm dia.) for zirconia oxygen sensor J-43897-12 (12 mm dia.) for titania oxygen sensor
(--) Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907)	Courtesy of NISSAN NORTH AMERICA, INC.	Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads
(--) Valve seat cutter set	Courtesy of NISSAN NORTH AMERICA, INC.	Finishing valve seat dimensions
(--) Valve guide drift	Courtesy of NISSAN NORTH AMERICA, INC.	Removing and installing valve guide
(--) Valve guide reamer	Courtesy of NISSAN NORTH AMERICA, INC.	1: Reaming valve guide inner hole 2: Reaming hole for oversize valve guide d1: 6.0 mm (0.236 in) dia. d2: 10.2 mm (0.402 in) dia.
(--) Manual lift table caddy	Courtesy of NISSAN NORTH AMERICA, INC.	Removing and installing engine
(--) Tube presser	Courtesy of NISSAN NORTH AMERICA, INC.	Pressing the tube of liquid gasket
(--) Engine stand	Courtesy of NISSAN NORTH AMERICA, INC.	Engine overhaul
(--) Drift	Courtesy of NISSAN NORTH AMERICA, INC.	Installing front oil seal a: 57.0 mm (2.244 in). b: 45.0 mm (1.772 in).
(--) Drift	Courtesy of NISSAN NORTH AMERICA, INC.	Installing rear oil seal a: 115.0 mm (4.528 in). b: 90.0 mm (3.543 in).
(--) Compression gauge set	Courtesy of NISSAN NORTH AMERICA, INC.	Compression pressure 1: Compression gauge 2: Adapter
Lock nut crimp punch (Cold chisel)	Courtesy of NISSAN NORTH AMERICA, INC.	Installing wheel hub lock nut a: 5 mm (0.20 in) b: 7 mm (0.28 in)