Removal Of Liquid Gasket Sealing

WARNING: This page is about a different variant/trim than selected.

After removing the bolts and nuts, separate the mating surface and remove the liquid gasket using Tool (A).

Courtesy of NISSAN NORTH AMERICA, INC.

Tool Number

: KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.

In areas where the cutter is difficult to use, use a plastic hammer to lightly tap (1) the cutter where the liquid gasket is applied. Use a plastic hammer to slide (2) the cutter by tapping on the side.

CAUTION: Do not damage the mating surfaces.