PR25DD engine: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the engine oil pressure control solenoid valve and tighten bolts to the specified torque in the sequence shown.
Bolts
: 9.0 N.m (0.9 kg-m, 80 in-lb)
CAUTION:- Do not reuse O-rings.
- Ensure engine oil pressure control solenoid valve O-ring sealing surface is free from dents or flaws.
- Apply clean engine oil to O-rings.
- Ensure engine oil pressure control solenoid valve harness is pushed to baffle side to avoid interference with upper oil pan and oil strainer.
- Install the oil strainer and tighten bolts to the specified torque in the sequence shown.CAUTION: Do not reuse O-ring.
Bolts
: 9.0 N.m (0.9 kg-m, 80 in-lb)
- Installation of the remaining components is in the reverse order of removal.
- Refill engine oil. Refer to ENGINE OIL : Refilling .