PR25DD engine: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by turning it all the way.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
CAUTION:
Perform this step when the engine is cold.
- Drain engine coolant. Refer to Draining .
- Remove the air cleaner and air duct assembly. Refer to Removal and Installation .
- Remove the CVT water hose A from the CVT oil warmer and the water pump housing.
- Remove the CVT water hose B from the oil cooler and the thermal valve.
- Remove the thermal valve bolt and position aside the thermal valve bracket.
- Remove the thermal valve from CVT oil warmer and water outlet.