PR25DD engine: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by turning it all the way.
CAUTION:
Perform this step when the engine is cold.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
- Remove the core support cover. Refer to Exploded View (with fog lamp) or Exploded View (without fog lamp).
- Drain engine coolant from radiator. Refer to Draining .
- Remove the air cleaner and air duct. Refer to Removal and Installation .
- Remove CVT oil cooler hoses, CVT water hose A, and thermo valve from CVT oil warmer.
- Remove bolts and remove CVT oil warmer.