PR25DD engine

WARNING: This page is about a different variant/trim than selected.

CHECK LIN COMMUNICATION CIRCUIT

Turn ignition switch OFF.
Disconnect ECM harness connector and generator harness connector.

Check the continuity between ECM harness connector and generator harness connector.

ECM		Generator		Continuity
Connector	Terminal	Connector	Terminal	Continuity
F90	98	F7	2	Existed

Also check harness for short to power and short to ground.

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace error-detected parts.

REPLACE GENERATOR
1. Replace generator. Refer to Removal & Installation .
2. Erase DTC.
3. Perform DTC confirmation procedure again. Refer to DTC Description .
Is DTC detected again?

YES

Replace ECM. Refer to Removal & Installation .

NO

INSPECTION END