PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Perform " Throttle Valve Closed Position Learning". Refer to Work Procedure .
- Turn ignition switch ON.
- Set selector lever to D position.
- Check the voltage between ECM harness connector terminals as per the following conditions.
ECM
Condition
Voltage
Connector
+
-
Terminal
Sensor 1
F90
85
90
Accelerator pedal
Fully released
More than 0.36V
Fully depressed
Less than 4.75V
Sensor 2
89
Fully released
Less than 4.75V
Fully depressed
More than 0.36V
Is the inspection result normal?
YES
INSPECTION END
NO
Replace electric throttle control actuator. Refer to Removal & Installation .