PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK THROTTLE CONTROL MOTOR
- Turn ignition switch OFF.
- Disconnect electric throttle control actuator harness connector.
- Check the resistance between electric throttle control actuator terminals as per the following.
Electric throttle control actuator
Resistance
(Approx.)
+
-
Terminals
5
6
1 - 15 Ohm [at 25 deg. C (77 deg. F)]
Is the inspection result normal?
YES
INSPECTION END
NO
Replace electric throttle control actuator. Refer to Removal & Installation .