LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (4 Of 4)) >> DTC/Circuit Diagnosis >> P2615 Intake Camshaft Position Sensor >> DTC Diagnosis Procedure >> PR25DD engine

PR25DD engine

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC PRIORITY 

    If DTC P2615 is displayed with DTC P0340, first perform the confirmation procedure (trouble diagnosis) for DTC P0340.

    Is DTC P0340 detected?

    YES

    Perform diagnosis of applicable. DTC Description

    NO

    GO TO 2.

  2. CHECK INTAKE CAMSHAFT POSITION (CMP) SENSOR SIGNAL CIRCUIT FOR ELECTRIC INTAKE VALVE TIMING CONTROL 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector and electric intake valve timing control module harness connector.
    3. Check the continuity between ECM harness connector and electric intake valve timing control module harness connector.

      ECM

      Electric intake valve timing control module

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      F91

      25

      F92

      37

      Existed
    4. Also check harness for short to power and short to ground.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Repair or replace error-detected parts.

scientia non olet · About LEMON Manuals