LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (4 Of 4)) >> DTC/Circuit Diagnosis >> P2413 EGR System >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC PRIORITY 

    DTC P2413 is displayed with DTC P0401 or P0402, first perform the trouble diagnosis for DTC P0401 or P0402.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TEST CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start the engine and warm it up to normal operating temperature.
    2. Drive the vehicle at least 20 seconds at 60 km/h (37 MPH) or more.
      CAUTION: Always drive vehicle at a safe speed.
    3. Check DTC.

    Is DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals