PR25DD engine
- CHECK APP SENSOR 2 POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect accelerator pedal position (APP) sensor harness connector.
- Turn ignition switch ON.
- Check the voltage between APP sensor harness connector and ground.
+
-
Voltage
(Approx.)
APP sensor
Connector
Terminal
E40
2
Ground
5 V
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK SENSOR POWER SUPPLY 2 CIRCUIT
Refer to Diagnosis Procedure .
Is inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit.
NO
Repair or replace error-detected parts.
- CHECK APP SENSOR 2 GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between APP sensor harness connector and ECM harness connector.
+
-
Continuity
APP sensor
ECM
Connector
Terminal
Connector
Terminal
E40
6
E31
154
Existed
- Also check harness for short to power.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace error-detected parts.
- CHECK APP SENSOR 2 INPUT SIGNAL CIRCUIT
- Check the continuity between APP sensor harness connector and ECM harness connector.
+
-
Continuity
APP sensor
ECM
Connector
Terminal
Connector
Terminal
E40
1
E31
153
Existed
- Also check harness for short to ground and to power.
Is the inspection result normal?
YES
GO TO 5.
NO
Repair or replace error-detected parts
- Check the continuity between APP sensor harness connector and ECM harness connector.
- CHECK APP SENSOR
Check the APP sensor. Refer to Component Inspection .
Is the inspection result normal?
YES
Check intermittent incident. Refer to Inspection .
NO
Replace accelerator pedal assembly. Refer to Removal & Installation .