PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK ICC STEERING SWITCH
- Disconnect combination switch (spiral cable) harness connector.
- Check the resistance between combination switch harness connector terminals as per the following conditions.
Combination switch
(Spiral cable)
Condition
Resistance
(Approx.)
Connector
+
-
Terminals
M88
21
36
MAIN switch: Pressed
Approx. 0
CANCEL switch: Pressed
Approx. 310
DISTANCE switch: Pressed
Approx. 740
SET- switch: Pressed
Approx. 1, 410
RES+ switch: Pressed
Approx. 2, 590
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ICC steering switch. Refer to ICC STEERING SWITCH : Removal & Installation .