LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (4 Of 4)) >> DTC/Circuit Diagnosis >> Fuel Pump >> Component Inspection >> PR25DD engine

PR25DD engine

WARNING: This page is about a different variant/trim than selected.
  1. CHECK FUEL PUMP 
    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
    3. Check resistance between "fuel level sensor unit and fuel pump" terminals as follows.

      Fuel level sensor unit and fuel pump

      Resistance

      +

      -

      Terminal

      5

      6

      0.2 - 5.0Ohm [at 25 deg. C (77 deg. F)]

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace "fuel level sensor unit and fuel pump". Refer to Removal & Installation (AWD) or Removal & Installation (FWD).

scientia non olet · About LEMON Manuals