PR25DD engine

1. Turn ignition switch OFF.
2. Remove fuel injector relay. Refer to Component Location .
3. Check the continuity between fuel injector relay terminals as per the following conditions.

   Courtesy of NISSAN NORTH AMERICA, INC.

   +	-	Condition	Continuity
   Fuel injector relay
   Terminal
   		12 V direct current supply between terminals and	Existed
   		No current supply	Not existed
   		12 V direct current supply between terminals and	Existed
   		No current supply	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace fuel injector relay. Refer to Component Location .