LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (4 Of 4)) >> DTC/Circuit Diagnosis >> Engine Oil Pressure Sensor >> Component Inspection >> PR25DD engine

PR25DD engine

WARNING: This page is about a different variant/trim than selected.
  1. CHECK EOP SENSOR 
    1. Turn ignition switch OFF.
    2. Disconnect EOP sensor harness connector.
    3. Check resistance between EOP sensor connector terminals.

      EOP sensor

      Condition

      Resistance (kOhm)

      +

      -

      Terminal

      1

      2

      None

      4 kOhm- 10 kOhm

      3

      2 kOhm- 8 kOhm

      2

      1

      4 kOhm- 10 kOhm

      3

      1 kOhm- 3 kOhm

      3

      1

      2 kOhm- 8 kOhm

      2

      1 kOhm- 3 kOhm

    Is the inspection result normal?

    YES

    INSPECTION END.

    NO

    Replace EOP sensor. Refer to Component Location .

scientia non olet · About LEMON Manuals