PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK BATTERY CURRENT SENSOR
- Turn ignition switch OFF.
- Reconnect harness connectors disconnected.
- Disconnect battery negative cable.
- Install jumper cable between battery negative terminal and body ground.
- Turn ignition switch ON.
- Check the voltage between ECM harness connector and ground.
ECM
Voltage
(Approx.)
Connector
+
-
Terminal
F91
56
45
2.5 V
Before measuring the terminal voltage, confirm that the battery is fully char deg. Refer to Work Procedure .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace battery negative cable assembly.