PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK ASCD STEERING SWITCH
- Disconnect combination switch (spiral cable) harness connector.
- Check the resistance between combination switch harness connector terminals as per the following conditions.
Combination switch
(Spiral cable)
Condition
Resistance
(Approx.)
Connector
+
-
Terminals
M88
21
36
MAIN switch: Pressed
0 Ohm
CANCEL switch: Pressed
250 Ohm
SET- switch: Pressed
660 Ohm
RES+ switch: Pressed
1, 480 Ohm
All ASCD steering switches: Released
4, 000 Ohm
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ASCD steering switch. Refer to Component Location .