PR25DD engine

1. Refuel 10 liter (8 Imp qt).
   CAUTION: Never refuel more than 10 liter.
2. Start the engine and keep the engine speed at 3, 000 rpm for 30 seconds.
   NOTE: For best results, warm up the engine until "COOLANT TEMP/S" on "DATA MONITOR" mode of "ENGINE" using CONSULT reaches at least 70 deg. C (158 deg. F).
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Turn ignition switch ON.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Turn ignition switch ON.
7. Erase DTC.
8. Start engine and let it idle for at least 60 seconds.
9. Perform DTC Confirmation Procedure, again. Refer to DTC Description .

Is 1st trip DTC detected?

YES

GO TO 2.

NO

INSPECTION END

Check fuel pump. Refer to Component Function Check .

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace malfunctioning part.

Check high pressure fuel pump. Refer to Component Inspection .

Is the inspection result normal?

YES

Check fuel hose connection.

NO

Repair or replace malfunctioning part.