DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE-1
Start the engine.
Does the engine start?
YES
GO TO 3.
NO
Proceed to DTC Diagnosis Procedure .
- PERFORM DTC CONFIRMATION PROCEDURE-2
- Start the engine and warm it up to normal operating temperature.NOTE: For best results, warm up the engine until "COOLANT TEMP/S" on "DATA MONITOR" mode of "ENGINE" using CONSULT reaches at least 70 deg. C (158 deg. F).
- Keep the engine speed at 3, 500 rpm for 5 seconds and let it idle at least 1 minute.
- Check 1st trip DTC.NOTE: If the fuel tank has sufficient fuel, this diagnosis result may not be detected.
Is 1st trip DTC detected?
YES
Proceed to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END
- Start the engine and warm it up to normal operating temperature.