DTC Confirmation Procedure

Do you have CONSULT?

Do you have CONSULT?

YES

GO TO 2.

NO

GO TO 5.

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO 3.

With CONSULT

1. Turn ignition switch ON.
2. Select "P/N POSI SW" in "DATA MONITOR" mode of "ENGINE" using CONSULT. Then check the "P/N POSI SW" signal as per the following conditions.

   Selector lever position	Known-good signal
   N or P position	ON
   Except above position	OFF

Is the inspection result normal?

YES

GO TO 4.

NO

Refer to DTC Diagnosis Procedure .

1. Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
2. Start engine and warm it up to normal operating temperature.
3. Maintain the following conditions for at least 60 consecutive seconds.
   CAUTION: Always drive vehicle at a safe speed.

   ENG SPEED	1, 000 - 6, 375 rpm
   COOLAN TEMP/S	More than 65 deg. C (149 deg. F)
   B/FUEL SCHDL	3.25 - 31.8 msec
   VHCL SPEED SE	More than 64 km/h (40 mph)
   Selector lever	Suitable position

4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Refer to DTC Diagnosis Procedure .

NO

INSPECTION END

Perform component function check. Refer to Component Function Check .

Is the inspection result normal?

YES

INSPECTION END

NO

Refer to DTC Diagnosis Procedure .