LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (3 Of 4)) >> DTC/Circuit Diagnosis >> P06DA Engine Oil Pressure Control Solenoid Valve >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start the engine.
    2. Maintain engine speed at 4, 500 rpm or more for at least 5 seconds.
    3. Check DTC.

    Is DTC detected?

    YES

    DTC Diagnosis Procedure 

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals