LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (3 Of 4)) >> DTC/Circuit Diagnosis >> P0607 ECM >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON (engine stopped) and wait least 10 seconds.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    DTC Diagnosis Procedure 

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals