LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (Re0F10D) (1 Of 2)) >> Basic Inspection >> Stall Test >> Work Procedure >> CVT: Re0F10D >> Work Procedure

Work Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Check the engine oil level. Replenish if necessary. Refer to ENGINE OIL : Inspection .
  2. Check for leak of the CVT fluid. Refer to CVT FLUID : Inspection .
  3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80 deg. C (122 to 176 deg. F).
  4. Be sure to apply the parking brake and block the tires.
  5. Start the engine, depress the brake pedal and shift to the D position.
  6. While depressing the brake pedal, depress the accelerator pedal gradually.
  7. Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
    CAUTION: Do not depress the accelerator pedal for 5 seconds or more during the test.

    Stall speed

    : Stall Speed
  8. Shift the N position.
  9. Cool the CVT fluid.
    CAUTION: Run the engine with the idle speed for at least 1 minute.
  10. Put the selector lever to the R position and perform Step 6 to Step 9 again.
scientia non olet · About LEMON Manuals