Work Procedure

WARNING: This page is about a different variant/trim than selected.

PERFORM CALIBRATION OF DECEL G SENSOR [ABS actuator and electric unit (control unit)]
Perform calibration of decel G sensor. Refer to Work Procedure .

GO TO 2.
PREPARATION BEFORE CALIBRATION PROCEDURE
1. Park the vehicle on a level surface.
2. Adjust air pressure of all tires to the specified pressure. Refer to TIRE AIR PRESSURE : Service Data .
GO TO 3.
PERFORM DECEL G SENSOR CALIBRATION (TCM)
With CONSULT
1. Turn ignition switch ON.
  CAUTION: Never start engine.
2. Select "Work Support" in "TRANSMISSION".
3. Select "G SENSOR CALIBRATION".
4. Touch "Start".
  CAUTION: Never rock or jounce the vehicle during "G sensor calibration".
Is "COMPLETED" displayed?

YES

WORK END

NO

Perform steps 3 again.