Component Function Check
- COMBINATION METER INPUT SIGNAL
CONSULT
- Select "Data Monitor" mode of "METER/M&A".
- Select "FUEL METER".
- Compare the "FUEL METER" value and the fuel gauge reading of the combination meter. Fuel
gauge and data monitor indications should be close.
Fuel gauge indication position
Reference value of data monitor [L]
(Approx.)
Full
55
3/4
43
1/2
31
1/4
20
Empty
6
Does the data monitor value approximately match the fuel gauge indication?
YES
Inspection End.
NO
Replace combination meter. Refer to COMBINATION METER : Removal & Installation .