PARKING BRAKE SHOE : Removal & Installation: Installation

Installation is in the reverse order of removal.

Apply PBC (Poly Butyl Cuprysil) grease or silicone-based grease to the back plate.

Install the adjusters (RH/LH) so that threaded part is expanded when rotating it in the direction shown by arrow.

Courtesy of NISSAN NORTH AMERICA, INC.

Check that the component parts of the parking brake shoe are properly installed.
CAUTION:
- The parking brake shoe (front) has a different lining material than the parking brake shoe (rear). Do not misidentify them during installation.
- Do not drop the removed parts.
Check the parking brake shoe lining and the drum inner surface for grease. Wipe off any grease on the surfaces.
Adjust the parking brake system. Refer to Adjustment .
Perform the break-in procedure. Refer to Periodic Maintenance Operation .