PRECAUTION FOR HARNESS REPAIR : Precautions

Solder the repaired area and wrap tape around the soldered area.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.