Work Procedure

CAUTION: When performing the following operations, always use CONSULT. (It cannot be performed by any means other than CONSULT.)

Removing/installing rear brake pad (When pressing piston of rear brake caliper assembly)
Replacing rear brake pad

BEFORE REMOVAL/REPLACEMENT OF REAR BRAKE PAD
CONSULT
1. Ignition switch OFF to ON.
  CAUTION: Never start the engine.
2. Select "EHS/PKB", "Active Test", and "Parking brake full release" according to this order.
  CAUTION:
  - Never operate the electric parking brake switch.
  - Never depress the brake pedal.
3. Touch "START".
GO TO 2.
REMOVAL AND INSTALLATION/REPLACEMENT OF REAR BRAKE PAD
Replace the rear brake pad. Refer to REAR BRAKE PAD : Removal & Installation .

GO TO 3.
PERFORM INITIALIZATION POSITION ADJUSTMENT
CONSULT
1. Select "EHS/PKB", "Work support", and "INITIALIZATION POSITION ADJUSTMENT" according to this order.
  CAUTION:
  - Never operate the electric parking brake switch.
  - Never depress the brake pedal.
2. Touch "START".
GO TO 4.
PERFORM THE SELF-DIAGNOSIS
CONSULT
1. Pull electric parking brake switch to activate electric parking brake.
2. Push electric parking brake switch to release electric parking brake.
3. Perform "EHS/PKB" self-diagnosis.
Is malfunction detected?

YES

Check the DTC. Refer to DTC Index .

NO

GO TO 7.
CHECK DATA MONITOR
CONSULT

Select "EHS/PKB", "Data Monitor", "BRAKE STATUS (LH)" and "BRAKE STATUS (RH)" according to this order. Check that signals are within the specified value. Refer to Physical Values .

Is the check result normal?

YES

GO TO 8.

NO

GO TO 1.
ERASE SELF-DIAGNOSIS MEMORY
CONSULT
1. Ignition switch ON.
  CAUTION: Be sure to wait for 10 seconds or more after turning the ignition switch OFF or ON.
2. Erase self-diagnosis results memory of "EHS/PKB".
Is the memory erased?

YES

Inspection End

NO

Check the items indicated by the self-diagnosis.