Diagnosis Procedure

The meter control switches are inoperative when pressed.

1. CHECK METER CONTROL SWITCH SIGNAL 

   Check the meter control switch signal. Refer to Diagnosis Procedure .

   Is the inspection results normal?

   YES

   GO TO 2.

   NO

   Repair or replace harness or connectors.

2. CHECK METER CONTROL SWITCH 

   Perform a unit check for the meter control switch. Refer to Component Inspection .

   Is the inspection results normal?

   YES

   Replace combination meter. Refer to COMBINATION METER : Removal & Installation .

   NO

   Replace meter control switch. Refer to METER CONTROL SWITCH : Removal & Installation .