Diagnosis Procedure

Transmits the washer fluid level switch signal to the combination meter.

1. CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT 
   1. Ignition switch OFF.
   2. Disconnect combination meter harness connector and washer fluid level switch harness connector.
   3. Check continuity between combination meter harness connector and washer fluid level switch harness connector.

      Combination meter		Washer fluid level switch		Continuity
      Connector	Terminal	Connector	Terminal
      M24	11	E208	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M24	11		No

   Is the inspection result normal?

   YES

   GO TO 2.

   NO

   Repair or replace harness or connectors.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT 

   Check continuity between washer fluid level switch connector and ground.

   Washer fluid level switch		Ground	Continuity
   Connector	Terminal
   E208	2		Yes

   Is the inspection result normal?

   YES

   Inspection End.

   NO

   Repair or replace harness or connectors.