DTC Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect combination meter harness connector and spiral cable harness connector.
3. Check continuity between combination meter harness connector and spiral cable harness connector.

   Combination meter		Spiral cable		Continuity
   Connector	Terminal	Connector	Terminal
   M24	10	M30	13	Yes
   	28		11

4. Check continuity between combination meter harness connector and ground.

   Combination meter		--	Continuity
   Connector	Terminal
   M24	10	Ground	No
   	28

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace harness or connector.