DTC Diagnosis Procedure
- CHECK FRONT COMBINATION LAMP POWER SUPPLY CIRCUIT
- Ignition switch ON.
- Turn the parking lamps ON.
- Check voltage between front combination lamp LH (upper), front combination lamp LH (lower), front combination lamp RH (upper) or front combination lamp RH (lower) connectors and ground.
+
--
Voltage
(Approx.)
Front combination lamp
Ground
Battery voltage
Connector
Terminal
LH (lower)
E232
7
LH (upper)
E240
8
RH (lower)
E231
7
RH (upper)
E241
8
Is the inspection result normal?
YES
Refer to Inspection .
NO
GO TO 2.
- CHECK FRONT COMBINATION LAMP SHORT CIRCUIT TO GROUND
- Ignition switch OFF.
- Disconnect front combination lamp LH (upper) connector, front combination lamp LH (lower) connector, front combination lamp RH (upper) connector, front combination lamp RH (lower) connector and IPDM E/R connector.
- Check continuity between IPDM E/R harness connector and ground.
IPDM E/R
Ground
Continuity
Connector
Terminal
No
E200
56
E201
61
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to IPDM E/R : Removal & Installation .
NO
Repair or replace harness.