DTC Diagnosis Procedure
- CHECK FRONT FOG LAMP POWER SUPPLY CIRCUIT
- Ignition switch ON.
- Turn the front fog lamps ON.
- Check voltage between front fog lamp RH harness connector and ground.
+
--
Voltage
(Approx.)
Front fog lamp
Ground
Battery voltage
Connector
Terminal
RH
E225
1
Is the inspection result normal?
YES
Refer to Inspection .
NO
GO TO 2.
- CHECK FRONT FOG LAMP SHORT CIRCUIT TO GROUND
- Ignition switch OFF.
- Disconnect front fog lamp RH connector and IPDM E/R connector.
- Check continuity between IPDM E/R harness connector and ground.
IPDM E/R
Ground
Continuity
Connector
Terminal
E201
57
No
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to IPDM E/R : Removal & Installation .
NO
Repair or replace harness.