DTC Diagnosis Procedure

CHECK FRONT FOG LAMP POWER SUPPLY CIRCUIT

Ignition switch ON.
Turn the front fog lamps ON.
Check voltage between front fog lamp LH harness connector and ground.

+			--	Voltage (Approx.)
Front fog lamp
Connector		Terminal	Ground
LH	E224	1		Battery voltage

Is the inspection result normal?

YES

Refer to Inspection .

NO

GO TO 2.

CHECK FRONT FOG LAMP SHORT CIRCUIT TO GROUND

Ignition switch OFF.
Disconnect front fog lamp LH connector and IPDM E/R connector.
Check continuity between IPDM E/R harness connector and ground.

IPDM E/R		Ground	Continuity
Connector	Terminal
E200	51		No

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to IPDM E/R : Removal & Installation .

NO

Repair or replace harness.