Diagnosis Procedure

1. Turn Ignition Switch OFF.
2. Disconnect Combination Meter And Parking Brake Switch Connectors.
3. Check Connectors And Terminals For Deformation, Disconnection, Looseness Or Damage.

Is The Inspection Result Normal?

YES 

GO TO 2.

NO 

Repair Or Replace As Necessary.

Check Parking Brake Switch. Refer To COMPONENT INSPECTION .

Is The Inspection Result Normal?

YES 

GO TO 3.

NO 

Replace Parking Brake Switch. Refer To EXPLODED VIEW .

With CONSULT.

1. Connect Combination Meter Connector And Parking Brake Switch Connectors.
2. Turn Ignition Switch ON.
3. In "DATA MONITOR" Select "PARK BRAKE SW" And Check Parking Brake Switch Signal.

   Condition	DATA MONITOR
   Actuate Parking Brake	On
   Release Parking Brake	Off

Is The Inspection Result Normal?

YES 

Refer To WORK FLOW .

NO 

GO TO 4.

1. Turn Ignition Switch OFF.
2. Disconnect Combination Meter And Parking Brake Switch Connectors.
3. Check Continuity Between Combination Meter Connector M24 Terminal 10 And Parking Brake Switch Connector M130 Terminal 1.

   Combination Meter		Parking Brake Switch		Continuity
   Connector	Terminal	Connector	Terminal
   M24	10	M130	1	Yes

4. Check Continuity Between Combination Meter Connector And Ground.

   Combination Meter		-	Continuity
   Connector	Terminal
   M24	10	Ground	No

Is The Inspection Result Normal?

YES 

Replace Combination Meter. Refer To REMOVAL AND INSTALLATION .

NO 

Repair Or Replace Malfunctioning Components.