Diagnosis Procedure (With Manual A/C)

1. Turn Ignition Switch ON.
2. Check Voltage Between Combination Meter Harness Connector And Ground.

   (+)		(-)	Voltage (Approx.)
   Combination Meter		Ground	5 V
   Connector	Terminal
   M24	32

Is The Inspection Result Normal?

YES 

Inspection End.

NO 

GO TO 2.

1. Turn Ignition Switch OFF.
2. Disconnect Combination Meter Connector And A/C Auto Amp. Connector.
3. Check Continuity Between Combination Meter Harness Connector And A/C Auto Amp. Harness Connector.

   Combination Meter		A/C Auto Amp.		Continuity
   Connector	Terminal	Connector	Terminal
   M24	32	M33	23	Yes

4. Check Continuity Between Combination Meter Harness Connector And Ground.

   Combination Meter		Ground	Continuity
   Connector	Terminal
   M24	32		No

Is The Inspection Result Normal?

YES 

Inspection End.

NO 

Repair Or Replace Harness Or Connector.