LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Rogue S, AWD >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires, Wheels & Tire Pressure Monitoring System (TPMS) (Except Hybrid) >> Basic Inspection >> Configuration (Tire Pressure Monitoring System) >> Work Procedure

Work Procedure

CAUTION:
  • After configuration, perform the following:
    • Turn the ignition switch from OFF to ON and check that the low tire pressure warning lamp turns OFF after staying illuminated for approximately two seconds.
    • Perform tire pressure sensor ID registration. Refer to WORK PROCEDURE .
  • If TPMS configuration is not completed, TPMS transmitter ID registration will not complete.

  1. CHECKING ECU IDENTIFICATION NUMBER

    G-20 CONSULT

    1. Select "ECU Identification" of "BCM".
    2. Write down ECU part number.

    GO TO STEP 2  .

  2. RE/PROGRAMMING, CONFIGURATION

    G-20 CONSULT

    1. Select "Re/programming, Configuration" from home screen.
    2. Check box confirming the precautions have been read.
    3. Select "Next".

    Is "Manual Selection (Vehicle Name)" displayed?

    YES 

    GO TO STEP 3  .

    NO 

    GO TO STEP 4  .

  3. VEHICLE SELECTION

    G-20 CONSULT

    1. Select Vehicle Make, Vehicle Name, and correct model year.
    2. Press "Select".

    GO TO STEP 4  .

  4. VEHICLE CONFIRMATION

    G-20 CONSULT

    1. Verify VIN or Chassis Number matches the vehicles VIN.
    2. Select "Confirm".

    GO TO STEP 5  .

  5. INPUT VIN

    1. Verify VIN number in dialog box matches vehicles VIN.
    2. Select "Confirm".

    GO TO STEP 6  .

  6. SYSTEM SELECTION

    G-20 CONSULT

    Select "AIR PRESSURE MONITOR".

    GO TO STEP 7  .

  7. OPERATION SELECTION

    1. Select "Manual Configuration"
    2. Select the DATA PART NO. that matches the BCM part number written down in step 1.
    3. Select "Next".

    GO TO STEP 8  .

  8. WRITE CONFIGURATION

    G-20 CONSULT

    1. Confirm that the correct DATA PART NO. is listed.
    2. Select "OK".

    GO TO STEP 9  .

  9. CHECKING LOW TIRE PRESSURE WARNING LAMP

    1. Turn the ignition switch OFF.
    2. Turn the ignition switch ON and check that the low tire pressure warning lamp turns OFF after staying illuminated for approximately two seconds.
      CAUTION:

      Never start the engine.

    Is the inspection result normal?

    YES 

    GO TO STEP 10  .

    NO 

    Perform the "Self Diagnostic Result" in "AIR PRESSURE MONITOR". Refer to CONSULT FUNCTION .

  10. PERFORMING SUPPLEMENTARY WORK

    1. Perform tire pressure sensor ID registration. Refer to WORK PROCEDURE .
    2. Perform the self-diagnosis of all systems.
    3. Erase self-diagnosis results.

    End of work.

scientia non olet · About LEMON Manuals