LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Rogue S, AWD >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires, Wheels & Tire Pressure Monitoring System (TPMS) (DTC/Circuit Diagnosis) (Except Hybrid) >> DTC/Circuit Diagnosis >> DTC C1708, C1709, C1710, C1711: Transmitter (No Data) >> Diagnosis Procedure

Diagnosis Procedure

NOTE:

The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs
  • Display tire pressure reported by the TPMS sensor
  • Read TPMS DTCs
  • Register TPMS sensor IDs

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

  1. CHECK TIRE PRESSURE SIGNAL

    G-20With CONSULT 

    1. Select "Data Monitor" mode in "AIR PRESSURE MONITOR".
    2. Check that the air pressures match the specified value.
      Monitor item Displayed value
      AIR PRESS FL Approximately equal to specified value. Refer to TIRE AIR PRESSURE .
      AIR PRESS FR
      AIR PRESS RR
      AIR PRESS RL

    Are all tire pressures displayed 0 kPa (psi)?

    YES 

    GO TO STEP 2. 

    NO 

    Replace applicable tire pressure sensor. Refer to REMOVAL AND INSTALLATION .

  2. CHECK BCM POWER CIRCUIT

    Check voltage between BCM connector M20 terminal 161 and ground.

    BCM Ground Voltage
    (Approx.)
    Connector Terminal
    M20 161 - Battery voltage

    Is the inspection result normal?

    YES 

    GO TO STEP 3. 

    NO 

    Repair or replace harness or connectors.

  3. CHECK BCM GROUND CIRCUIT

    Check continuity between BCM connector M20 and ground.

    BCM Ground Continuity
    Connector Terminal
    M20 170 - Yes
    171

    Is the inspection result normal?

    YES 

    GO TO 4.

    NO 

    Repair or replace harness or connectors.

  4. TIRE PRESSURE SENSOR ID REGISTRATION

    Perform tire pressure sensor ID registration. Refer to WORK PROCEDURE .

    Can the tire pressure sensor ID registration be completed?

    YES 

    GO TO STEP 5  .

    NO 

    Replace applicable tire pressure sensor. Refer to REMOVAL AND INSTALLATION .

  5. RECHECK TIRE PRESSURE SIGNAL

    G-20With CONSULT 

    1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
    2. Select "Data Monitor" mode in "AIR PRESSURE MONITOR".
    3. Check that the air pressures match the specified value.
      Monitor item Displayed value
      AIR PRESS FL Approximately equal to specified value. Refer to TIRE AIR PRESSURE .
      AIR PRESS FR
      AIR PRESS RR
      AIR PRESS RL

    Does Data Monitor display specified value without turning tire pressure warning lamp ON?

    YES 

    Inspection End.

    NO 

    Replace BCM. Refer to REMOVAL AND INSTALLATION (with Intelligent Key system) or REMOVAL AND INSTALLATION (without Intelligent Key system).

scientia non olet · About LEMON Manuals