Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect combination meter harness connector M76 and washer fluid level switch harness connector E82.
   3. Check continuity between combination meter harness connector M76 and washer fluid level switch harness connector E82.

      Combination meter		Washer fluid level switch		Continuity
      Connector	Terminal	Connector	Terminal
      M76	24	E82	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M76	24		No

   Is the inspection result normal?

   YES 

   GO TO STEP 2. 

   NO 

   Repair or replace harness or connector.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT
   
   

   Check continuity between washer fluid level switch connector and ground.

   Washer fluid level switch		Ground	Continuity
   Connector	Terminal
   E82	2		Yes

   Is the inspection result normal?

   YES 

   Inspection End.

   NO 

   Repair or replace harness or connector.