Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK STEERING SWITCH CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect combination meter harness connector M76 and spiral cable harness connector M30.
   3. Check continuity between combination meter harness connector M76 and spiral cable harness connector M30.

      Combination meter		Spiral cable		Continuity
      Connector	Terminal	Connector	Terminal
      M76	21	M30	14	Yes
      	22		8
      	23		15

   4. Check continuity between combination meter harness connector M76 and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M76	21		No
      	22
      	23

   Is the inspection result normal?

   YES 

   Inspection End.

   NO 

   Repair or replace harness or connector.