Component Inspection

1. Turn ignition switch OFF.
2. Disconnect meter control switch connector.
3. Check meter control switch.

   Meter control switch		Condition	Continuity
   Terminals
   7	4	When illumination control switch (-) is pressed	Yes
   		Other than the above	No
   5		When trip reset switch is pressed	Yes
   		Other than the above	No
   6		When illumination control switch (+) is pressed	Yes
   		Other than the above	No

Is the inspection result normal?

YES 

Inspection End.

NO 

Replace meter control switch. Refer to REMOVAL AND INSTALLATION .