Work Procedure

Two positions for the driver seat and outside mirror can be stored for memory operation by following procedure.

NOTE:

If memory is stored in the same memory switch, the previous memory will be deleted.

REGISTRATION METHOD
1. Adjust driver seat and outside mirror position manually.
2. Push set switch.
  NOTE:
  - Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
  - Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 second.
3. Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
  NOTE:
  - To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
  - To modify driver seat positions, memory indicator will be turned OFF for 0.5 second, then turned ON for 5 seconds.
4. Confirm the operation of each part with memory operation.
Inspection End.