Diagnostic Test

1. Perform "All DTC Reading" with CONSULT.
2. Check if the DTC is detected in self-diagnosis results for "LASER/RADAR" with CONSULT.

Is any DTC detected?

YES 

GO TO STEP 5  .

NO 

GO TO STEP 2  .

1. Turn ignition switch ON.
2. Check that "FEB SELECT" operates normally in "Data Monitor" for "LASER/RADAR" with CONSULT.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Replace the distance sensor. Refer to REMOVAL AND INSTALLATION .

1. Select the Active Test item "FEB SELECT" for "LASER/RADAR" with CONSULT.
2. Check if the FEB warning lamp illuminates when the test item is operated.

Is the inspection result normal?

YES 

Refer to WORK FLOW .

NO 

GO TO STEP 4  .

Check that "BA W/L" operates normally in "Data Monitor" for "METER/M&A" with CONSULT, when the FEB setting ON by steering switch.

Is the inspection result normal?

YES 

Replace the combination meter. REMOVAL AND INSTALLATION .

NO 

Replace the distance sensor. Refer to REMOVAL AND INSTALLATION .

Repair or replace malfunctioning parts.

GO TO STEP 6  .

Check that FEB warning lamp turned ON ==> OFF, when operating steering switch.

Inspection End.