LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Forward Emergency Braking System (Without ICC) (DTC/Circuit Diagnosis) (Except Hybrid) >> DTC/Circuit Diagnosis >> DTC C1A24: NP Range >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. CHECK DTC PRIORITY

    If DTC "C1A24" is displayed with DTC "U1000", first diagnose the DTC "U1000".

    Is applicable DTC detected?

    YES 

    Perform diagnosis of applicable. Refer to DTC LOGIC .

    NO 

    GO TO STEP 2  .

  2. CHECK DTC REPRODUCE (1)

    1. Start the engine.
    2. Turn the FEB system ON.
    3. Wait for approximately 5 minutes or more after shifting the selector lever to "P" position.
    4. Perform "All DTC Reading" with CONSULT.
    5. Check if the "C1A24" is detected as the current malfunction in "Self Diagnostic Result" mode of "LASER/RADAR".

    Is "C1A24" detected as the current malfunction?

    YES 

    Refer to DIAGNOSIS PROCEDURE .

    NO 

    GO TO STEP 3. 

  3. CHECK DTC REPRODUCE (2)

    1. Wait for approximately 5 minutes or more after shifting the selector lever to "N" position.
    2. Perform "All DTC Reading".
    3. Check if the "C1A24" is detected as the current malfunction in "Self Diagnostic Result" mode of "LASER/RADAR".

    Is "C1A24" detected as the current malfunction?

    YES 

    Refer to DIAGNOSIS PROCEDURE .

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals