DTC Confirmation Procedure

1. Turn the ignition switch OFF.
2. Wait for 10 minutes or more.
3. Start the engine.
4. Turn the FEB system ON.
5. Perform "All DTC Reading" with CONSULT.
6. Check if the "C1A21" is detected as the current malfunction in "Self Diagnostic Result" mode of "LASER/RADAR".

Is "C1A21" detected as the current malfunction?

YES 

Refer to DIAGNOSIS PROCEDURE .

NO - 1 

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO - 2 

Confirmation after repair: Inspection End.